Trulieve Stik Battery Instructions (2024)

FAQs

How do I turn on a Trulieve vape pen battery? ›

Click the stylus tip at the bottom 5 times to turn on the battery and it will illuminate. You can also change heat settings by clicking 2 times. If your pen needs charging, just plug it into your USB charger that comes with your vaporizer.

You'll know your battery is fully charged when the indicator light turns green or begins blinking steadily. On certain models, the charging light will shut off when the battery reaches 100%.

pen 2.0 Battery is our Rapid Charge Mode. The standard charging time for vape pens is typically 30-45 minutes (or more), but a simple swipe of the finger activates Rapid Charge Mode and the O. pen will be fully charged in only 20 minutes or less!

The best way to tell if your vape battery is bad is to take note of how it's performing. If it's not holding a charge as long as it used to, if the hits are weaker, or if it's leaking, those are all indicators that it needs to be replaced.

Battery Issues: One of the most frequent reasons a vape pen stops working is a depleted or malfunctioning battery. Ensure the battery is fully charged and properly connected. Sometimes, cleaning the battery contacts can improve connectivity and restore function.

To turn on your vape pen, quickly press the power button five times in rapid succession. The clicks should happen within 2-3 seconds. You may see indicator lights near the button flash a few times to confirm it has switched on.

Generally speaking, charging time can range from 1 to 3 hours for a standard-sized battery. However, it is crucial to follow the manufacturer's instructions specific to your electronic cigarette model to find the required charge time.

Generally speaking though, most mid-sized vape pen batteries in the 500-900mAh range take around 1-2 hours for a full charge using a decent quality charger. Higher capacity mods over 2000mAh may take 3-4 hours or more. And smaller disposable vape batteries typically recharge in 1-2 hours.

Take 3-4 quick puffs from the mouthpiece to prime the pen for an optimal experience. Once primed, take a slow steady inhale. The light on the end of the pen should light up. To recharge, take a micro USB cable and plug into the port located at the bottom of the unit.

It is easy to see which temperature has been selected by looking at the color of the LED ring around the central button. Each temperature is indicated by the corresponding vape pen color settings: red, blue, and green. BLUE = LOW / 2.5V. GREEN = MEDIUM / 2.75V. RED = HIGH / 3.0V.

Why is my pen not hitting but it's charged? ›

If your vape pen stops hitting after a charge (or it just won't charge at all), it might be a sign of a clogged cartridge, incompatible charger, or poorly screwed on component. Fortunately, these issues can be fixed in a few simple steps, so you don't have to throw out your device and buy a replacement.

When the vape pen is charging there will be be an LED light. Red LED light indicates it is not charged (a light on the plug part). When it is fully charged that light will go green. The AIO vape by Joytech, as shown in this picture. Will have the tank area LED light in red, when it is charged, the red light will stop.

Vape pen battery not working

To turn these pens on, you'll need to push the battery button five times quickly and hold the button down when you pull. If you're using your vape pen's battery correctly but it's not working, inspect the battery's contact point for damage or residue, like excess oil.

Activating your cartridge on the battery: Press the main button 5 times in rapid succession to turn the battery on or off.

Bring the mouthpiece to your lips and take a slow, steady draw. The pen will automatically activate, and you will begin to inhale vapor. Start with small puffs to get used to the device. Continue to take draws from the vape pen as needed.